Aluminum Foils Lids to Reuse Coffee Pods Compatible with VertuoLine by RECAPS 100 Pcs 62mm

RECAPS Filling Tool Holder Compatible with Vertuoline Coffee Pods (Aluminum lids and Empty Pods Not Included)

Café Bustelo Espresso Dark Roast Ground Coffee Brick, 10 Ounce

1. Take a used Nespresso Intenso Vertuo pod
2. Get a butter knife, insert it where the middle hole was punctured and slice down / up
3. Peel it off all the way around
4. Use a plastic spoon and take the grounds out; dump in to refuse bin
5. Wash with soap and water; dry it thoroughly
6. Take top piece off of holder, put empty pod in holder and put top piece on top of that
7. Use a measuring spoon and put in ~2.5-3 Tablespoons Bustelo ground espresso
8. Pick up and tap down on a table, the holder, a few times, to get the grounds tamped down. You may want to do this after every tablespoon pour to minimize the tap downs needed.
9. Peel a foil off of the paper, take off the top piece of the holder and center it as best you can on the pod and run your finger lightly around so its flat
10. Take a scissor and snip off the tab
11. Put the top piece back and press down while making a counter / clockwise motion a few times
12. Take the top piece off, pick up the pod and fold over and under with your finger going all the way around
13. Put the pod back in the holder and repeat step 11.
14. Repeat step 12
15. You can repeat 11 and 12 to make it three times, for utmost safety, but twice should be sufficient.
16. Pour some filtered water in the tank, turn on machine, wait for heat up, open chamber, put pod in, close and brew. After done, wait a few seconds (~5-10) then open the chamber to release the pod. Take the pod out of the spent area.
17. Enjoy!