I've combined a case like this and an adhesive kickstand like this.

Couple things--
Probably the only viable placement of the adhesive kickstand is below the camera and above the power button, like this.

This way, the added kickstand doesn't add any ADDITIONAL thickness to the case, since you can place it on the "recessed" part of the case design.

CAVEATS: Due to our wide angle lens, you have to attach the kickstand sufficiently far below the camera area to make sure the wide angle lens doesn't pick it up on the edges of the photo. In turn, this forces you to place the kickstand basically hovering over the top portion of the power button hole, a little bit. It doesn't completely block the power button (you can still press it, but with your finger tip point, not the "pads" of your fingers) so if you use the fingerprint sensor, then this probably will not work for you.

Also, due to the design of the kickstand (and the placement) it only works horizontally, if that matters to you.