It's done bro. Those look loose meaning some of them probably broke. If you put power to this it can be dangerous. Just get a new motor.

I just had to remove a stuck bearing just like this and it was a pain to figure out. I bought this puller.https://www.amazon.com/gp/product/B08XYNH2W2/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

I couldn't find any pullers or slide hammers that were thin enough to get behind the bearing without rubbing on the wires. So I removed the seal, slowly ripped out the wire that wraps around the ball bearings with a small flat head. Once the balls are loose in the race all you have to do is squeeze some vice grips around the outer race and it should pop off. Then the puller will fit around the inner race without touching the wires.