Stand: https://amazon.com/gp/product/B01NCZQ0ZZ/
What I used for feet since the pointy feet suck: https://amazon.com/gp/product/B07D7S8F3T/
LED lights: https://www.amazon.com/dp/B07MMNH5HH?ref=ppx_pop_mob_ap_share
The LED strips can be cut to size and I glued each diode to the back, 4 per shelf. Sanded the front of the acrylic to give it a frosted look so it lit up like that in the pic.
Pic of the back to see where the LEDs are positioned: https://i.imgur.com/bJ6jxqY.png
It was really easy. I just bought an led light strip like this:
Led Strip Lights 6.56ft for 40-60in TV USB Backlight Kit with Remote, 16 Color 5050 Bias HDTV, for 40-60 https://www.amazon.com/dp/B07MMNH5HH/ref=cm_sw_r_cp_api_i_IbAHFbNF7RKET
It was less than $10 and a little over 6 feet long and was almost the perfect length. I had a 2 inch gap, but can’t tell unless you really look.
I then just googled how to install them and this vid was perfect, but it was pretty self explanatory as the lights came with double sided tape attached and I stuck it around the outer edge of my board.
This vid isn’t as good, but’s it’s closer to my set up as I didn’t make any cuts to mine and my board had a usb. If your board doesn’t have a usb, too will have go tap into the battery, get a usb battery pack, or get the lights that are powered off if batteries not usb.
I used scotch tape to hold the wires up,but will probably trim the wires and another time.
I hope this helps!
Ah. Not lights but I have reflective HD Sidekicks on my XRs (Ferrari red on one, black/silver on the other) and those light up bright whenever lights hit them.
I used to have color-change LED strips mounted on the underside of the fender on one so that they did an underglow unto the tire and it looked super-cool, but I didn't cut a notch in my fender where it passed between fender and the footpad (the battery bank for power was mounted to the top of the fender so the strip had to pass under it), and when my friend rolled the board the fender cut the wire, and I never re-did it.
