Are you using a sheet of paper to level? For me the results were always hit or miss, I switched to 0.2mm feeler guages and adjust until the nozzle just barely touches and both adhesion and quality improved there is an amazon link below if you're curious what I mean.

Also it might be beneficial to start at the beginning with leveling.

Loosen the z stop switch screws that hold it just enough so it can slide down a little.

Now tighten all of the adjustment wheels completely snug, make them equally finger tight, then turn them back (loosen) 2 complete revolutions.

Now bring the gantry down using the move function for the z axis at the 0.1mm setting until it just touches but doesn't put any actual pressure against the bed, just kissing.

Gently slide the z stop switch up until it just clicks and tighten it down.

Then level as you normally would. This helped me immensely when I got my bed all out of whack a few days after getting my printer.

Good luck, don't get discouraged.

[0.2mm Feeler Guages]

https://www.amazon.com/dp/B07QWLVRG3/ref=cm_sw_r_sms_awdb_imm_SZF8NNT1YJNC4S8H4RRA?_encoding=UTF8