yup. the full kit. probably should have given a link. here you go Ive seen some get the individual parts, or using clones. I avoided clones just to limit headaches.

I made a mistake its not quite a drop in replacement, the mpsm uses JST connectors. and the full kits are just ferrules. So you'll need a set of connectors and a crimping tools. But hey, these are useful to have anyways.

this is the crimping tool id recommend

these are the jst connectors used for the hotend.

if your unfamiliar with crimping, here's a great video from teaching tech.

install was pretty simple. take off the fan (take of the spring clips), undo the 2 screws, take out the stock hotend.

open up the bottom to get at the main board. undo the hot end connectors (heater cartridge & thermistor) thread out the old cables. You can reuse the fan if desired.

thread in the new cables, plug in thermistor, crimp in the cartridge wires, then plug in the heater cartridge jst.

close up all the panels and reattach the springs holding the fan on (this is by far the most frustrating thing. )

re calibrate as needed.